Conventional wireline coring has been transformed. High frequency energy pulse assisted drilling (EPAD) enables the IMDEX COREVIBE™ to deliver a 30%* productivity gain, due to increases of up to 90% rate of penetration (ROP) whilst retaining good bit life, core quality and hitting targets.
High frequency energy pulse assisted drilling (EPAD) enables the IMDEX COREVIBE™ to deliver a 30%* productivity gain, due to increased Rate of Renetration (ROP) whilst retaining good bit life, core quality and hitting target.
*Validated by SGS, a world leading inspection, verification, testing and certification company.
Maintaining high and consistent ROP can be a challenge, especially when encountering hard rock conditions. Pulses emitted by IMDEX COREVIBE™ allow the drill bit to traverse difficult downhole conditions without affecting core quality or deviation, with up to 30% increase in productivity* due to increased Rate of Penetration (ROP). Hit your target by maximising core run lengths with IMDEX COREVIBE™.
Experience level and confidence will vary in any crew. With IMDEX COREVIBE™ in your fleet, highly productive drilling is achievable by drillers of any level and stripping the bit to keep it sharp is no longer an art form. No need to rely on the most experienced drillers to do the heavy lifting.
Additional costs caused by higher operational standards, environmental restrictions and increased hole depths will only get worse. The time is now to invest in drilling optimisation.
AMC’s team of fluid and equipment engineers resolves site-specific challenges and provides advice to reduce costs and improve productivity. For more information about our products, please contact your closest AMC representative.
Click the link below to find your closest AMC Office or a local distributor.
IMDEX XTRACTA™ allows the driller to inspect and/or change the bit/reamer each time the core is retrieved. This means there is no need to pull the rods to change bits and the hole is always cased, maintaining hole integrity.
The AMC 500 R™ RECYCLING UNIT is a German engineered purpose built fluid recycling unit designed to remove and dispose of drill cuttings in the mud flow cycle of the horizontal directional drilling and waterwell drilling industries.
Displacement plugs are used in diamond wireline drill rods and casings for placing cement plugs or casing pack fluid.
The MARSH FUNNEL is an instrument used to measure drilling fluid viscosity, commonly used with the AMC MEASURING CUP. The MARSH FUNNEL is molded from a tough, durable plastic that resists breaking or cracking. A brass orifice assures consistency in all readings.
